Pure edge mac. Am in dire need of a way out. Am using the xmodem to recover the image file for my 3550 switch but discovered that the flash might be full as in indicated in the output below. Please what is my next line of action.
Base ethernet MAC Address: 00:0c:ce:0f:bc:00
Xmodem file system is available.
The password-recovery mechanism is enabled.
Iosv Startup Config For Gns3
The system has been interrupted prior to initializing the
flash filesystem. The following commands will initialize
the flash filesystem, and finish loading the operating
system software:
Cisco Startup Config
switch: dir flash
unable to stat flash/: permission denied
switch:
switch:
switch: flash_init:
Unknown cmd: flash_init:
switch: flash_init
Initializing Flash..
flashfs[0]: 6 files, 1 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 15998976
flashfs[0]: Bytes used: 10177536
flashfs[0]: Bytes available: 5821440
flashfs[0]: flashfs fsck took 24 seconds.
..done Initializing Flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
switch:
switch:
switch:
switch: load_helper
switch:
switch: set BAUD 19200
ó¥Ö3»ú
switch: copy xmodem: flash:c3550-ipservicesk9-mz.122-44.SE6.bin
Begin the Xmodem or Xmodem-1K transfer now..
C.......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................flash:c3550-ipservicesk9-mz.122-44.SE6.bin: no space left on device
I show you how to add IOSv, IOSv L2 and IOS XR into GNS3 to run more complex labs. Connect the GNS3 Ether switch to the IOSv Layer Two switch and connect the switch to the router. So, we'll start off with a simply topology. I'll change the switch name to switch one, router name.